![]() ![]() Right-click on PC1 and then select Start to start it. Connect PC1 to port 1 of Ethernet switch and connect PC2 to port 2 of Ethernet switch. Drag two VPCS machines in the work view area. I used the following command (in red) to set the host's IPv6 address.But how can I set its default gateway's IPv6 address? Or is it not needed because the host would use ARP and its 'FE80' address to find the default gateway's 'FE80' address? In order to use VPCS in GNS3, you need to following steps: In the GNS3 console, drag an Ethernet Switch in the work view area. We can configure ip addressing and gateway to host by using this command ip. ![]() You need a license for J-Flash but it's independent of the IAR (or other) toolchain. Segger offers J-Flash, a PC software program that interfaces with the J-Link debug probe to program the flash memory on a target.
0 Comments
Leave a Reply. |